Fukushima faced 14-metre tsunami

Wednesday, 23 March 2011

Tokyo Electric Power Company has revised its estimated size of the earthquake and tsunami that hit the Fukushima Daiichi nuclear power plant.

 

 

Precision injection of water via concrete pump at Fukushima Daiichi 4

This is the third upward revision of tsunami's scale since it disabled emergency power generators and heat removal pumps at Fukushima Daiichi on 11 March. The loss of these systems left units 1, 2 and 3 in severe trouble that has only stabilised after the write-off of the reactors, which are now being cooled by seawater injection. Some used fuel ponds at the site remain a serious concern and spraying to maintain water levels is ongoing.

 

 

In early statements, Tepco had said the tsunami was at least seven metres high. Later the company increased its estimate to ten metres at the Daiichi plant and 12 metres at Daini. Today's figures describe a 14-metre tsunami at both plants. By regulation, the Daiichi plant was fully prepared for a tsunami of up to 5.7 metres. At Daini, ten kilometres along the coast, the design basis was 5.2 metres.

 

More detailed data of the ground acceleration rates caused by the magnitude 9.0 earthquake have also been made available by Tepco. Although not all the data has yet been collected, they record very powerful tremors that exceed the design basis in one dimension.

 

At the Daini plant, ground accelerations ranged from 186 gal in the vertical plane at unit 1 to 277 gal from north to south at unit 3, as recorded by sensors in the reactor building foundation. The range of design basis figures is a spread from 415 gal to 512 gal.

 

At Daiichi there is still no data for units 1, 2 and 5, but available figures put the maximum acceleration as 507 gal from east to west at unit 3. The design basis for this was 441 gal. Other readings were below design basis, although east-west readings at unit 6 of 431 gal approached the design basis of 448 gal.
 
Researched and written
by World Nuclear News